DIY Adapter recognized In Launcher but not working PS3

[ShatteredFox]

Hi, I received all the pieces for my adapter today and followed the guide step by step, installed all the drivers and firmware properly and made a config. The adapter shows up in the launcher and is recognized as COM4 however when I hit start I can't control my PS3. I've followed the guide twice over and still nothing seems to be working. Any help on this issue would be great appreciated.

[ckaiycool]

Set the gimx controller as nr 1?

[ShatteredFox]

I'll be honest with you, i've got no idea what you mean by nr 1, i'm fairly new to this.

This is what shows up in GIMX launcher

Do I need to already have a Dualshock 3 controlled turned on or plug things in a certain order? I followed the DIY Guide for Dummies also if that helps.

[Matlo]

Hi,
The "No controller detected" error message usually indicates a wrong wiring. Please take a clear photo of your adapter and post it.

[ShatteredFox]

In case you can't make it out -
RXI = D2
TX0 = D3
GND = GND

[Matlo]

The correct wiring is:
GND -> GND
D2 -> TXO
D3 -> RXI

There was actually a note in the wiki that was suggesting to read another wiki page in case the USB to UART adapter differs. To make it more explicit I added a wiring table: http://gimx.fr/wiki/index.php?title=DIY ... he_adapter

[ShatteredFox]

Thanks for the quick replies, i'll make the correct adjustments later when I get home and post about how it went.

[ShatteredFox]

Got it working, you're my hero Matlo. Thanks.