Hi I have successfully got my g27 working thanks for this great software solution
Now I also have
a fanatec csr not elite I've put it in PS3 mode
"
Put your CSR wheel into PS3 mode (G25 mode), and use gimx-config to replace the G27 bindings.
If you have further issues, the support section is the right place to post."
But I'm not sure
How to replace the g27 bindings
I just get g27 not found
Thanks for any help
Fanatec csr
Re: Fanatec csr
Hi,
I pushed G25 configs into the GIMX config repository. You can get them using the "Help>Download Configs" menu in gimx-launcher. There's a specific one for Windows 10.
I pushed G25 configs into the GIMX config repository. You can get them using the "Help>Download Configs" menu in gimx-launcher. There's a specific one for Windows 10.
Modifying a config is easy: open it with gimx-config ("File>Edit config" in gimx-launcher), select a line, click on Modify, change some parameters, click apply, and save.Mrgonuts wrote:But I'm not sure how to replace the g27 bindings
GIMX creator
Re: Fanatec csr
Thanks I'm getting closer still says g25 not found but I can now control the ps4 load drive club use the menu but the throttle and I would think the brake doesn't work either
Thanks for your help
I'm on win 7
If I need to post any other specs let me know
Cheers Robin
Thanks again for this great software
Thanks for your help
I'm on win 7
If I need to post any other specs let me know
Cheers Robin
Thanks again for this great software
Re: Fanatec csr
Hi thanks again for your time and support
I know fully understand the Gimx config
The problem was all my fault I had slightly unplugged the pedals when trying to put the wheel in PS3 mode as it's built in to my arcade machine it wasn't easy to see
http://postimg.org/image/e6psef47n
Thanks again
The only problem I have now is disconnections so I'm reading all threads on that and checking all connections and cables next step install unbent and try on that
So the fanatec csr works with your great software you done a great job well done
Cheers
I know fully understand the Gimx config
The problem was all my fault I had slightly unplugged the pedals when trying to put the wheel in PS3 mode as it's built in to my arcade machine it wasn't easy to see
http://postimg.org/image/e6psef47n
Thanks again
The only problem I have now is disconnections so I'm reading all threads on that and checking all connections and cables next step install unbent and try on that
So the fanatec csr works with your great software you done a great job well done
Cheers