2 gimx controllers on the same xbox 360

[oldschl]

Hello. First off thanks for this great piece of software. I have been looking for something like this for a long time.

I would like to use two gimx controllers on the same xbox 360. I have two dyi cables each plugged into a different computer running the gimx software and each with its own wired controller. However the xbox only activates the first controller slot. Which ever gimx launcher was activated last takes over spot number 1. How do i make it so that one PC comes up as controller one on the xbox and the other PC comes up as controller number two. They are both windows 7 32bit PC's running the windows ver. 5.5 of gimx. Both DYI cables are using the atmega32u4.hex. Any help would be appreciated. I have searched everywhere but I do not really see anyone with this issue. I must be missing something.

My Command Line for the Pc's is
gimix.exe -p COM3 -c "Config File.xml" --subpos

[Matlo]

Hi,

Do you use two different controllers for the authentication?

[oldschl]

Thank you for your quick reply. Yes i do have two different controllers. Each plugged into a different pc.

[Matlo]

There's probably a bug in the firmware. I opened #364.

[oldschl]

Oh ok. Should I try another firmware? Should the two cables have two different firmwares on them? If so which ones? I am using atmega32u4.hex right now on both. Thanks again.