Requesting Help Getting Everything Running

[Matlo]

Try to enable Output>GUI, and see if there is reaction to your controls.

[DrumsXO]

There isn't when I try it with my 360, but there is when I use my PS3...

Is the Ring of Light on the 360 controller supposed to flash constantly after Zadig installs the libusbk driver? Because that's what happens.

Also, the controller stays plugged into the PC, right? I don't unplug it and plug it into the 360 after I start GIMX?

[Matlo]

There isn't when I try it with my 360, but there is when I use my PS3...

And you use the same config in both cases?

Please post the content of your config.

[DrumsXO]

No, I don't. For the PS3 I chose the Battlefield 3 on by McKack and for the 360 I used the default Windows 360 Pad one.

I'm so confused by all of this.

[Matlo]

The Windows 360 pad config is only usable with the default driver, not with the libusbK one.

[DrumsXO]

Oh... Not according to the Wiki...

So I just need to go back to the default driver and it should work? How do I configure the keyboard and mouse controls?

[Matlo]

The wiki does not state that you can use the 360 controller for both the authentication and controls.

What you can do is use the libusbK driver for the spoof, stop GIMX (let the teensy plugged), restore the default driver, and start GIMX again.

[DrumsXO]

So, install the libusb driver, start GIMX and spoof, then close GIMX, leave the Teensy plugged in, install the stock driver and then start GIMX again?

Or do I unplug and replug the Teensy? You said "let the teensy plugged," which doesn't make sense.

[Matlo]

As long as the teensy remains plugged and as long as the 360 is on, the teensy is still authenticated as a genuine 360 controller.

If you turn the 360 off or unplug the teensy, the teensy will have to authenticate again.

[DrumsXO]

Okay, so I leave it plugged in and the 360 on when I switch back to the default driver?

When I want to configure the mouse and keyboard controls, do I open the FPS Config thing, or something else?