360 Spoof Issues (Solved)
360 Spoof Issues (Solved)
.
Last edited by peshkohacka on Sun Jun 22, 2014 6:35 pm, edited 3 times in total.
Re: 360 Spoof Issues
.
Last edited by peshkohacka on Sun Jun 22, 2014 6:34 pm, edited 1 time in total.
Re: 360 Spoof Issues
.
Last edited by peshkohacka on Sun Jun 22, 2014 6:34 pm, edited 1 time in total.
Re: 360 Spoof Issues (Solved)
Hi,
The EMU360 in the trunk is meant to be used with the usbspoof from the trunk!
I made a few changes in both the EMU360 and the usbspoof.
I believe it should work as-is with any controller version, but I only have 1.10 controllers, so that I can't test it.
It would be nice if you could test it. You'll need to compile and install both the EMU360 and the usbspoof.
The EMU360 in the trunk is meant to be used with the usbspoof from the trunk!
I made a few changes in both the EMU360 and the usbspoof.
I believe it should work as-is with any controller version, but I only have 1.10 controllers, so that I can't test it.
It would be nice if you could test it. You'll need to compile and install both the EMU360 and the usbspoof.
GIMX creator
Re: 360 Spoof Issues (Solved)
.
Last edited by peshkohacka on Sun Jun 22, 2014 6:34 pm, edited 1 time in total.
Re: 360 Spoof Issues (Solved)
One of my controllers is the same as your controller.
I forgot to tell you that the teensy is now waiting for a byte before initializing the usb stack.
It has to be plugged to the 360 before running usbspoof.
I forgot to tell you that the teensy is now waiting for a byte before initializing the usb stack.
It has to be plugged to the 360 before running usbspoof.
GIMX creator
Re: 360 Spoof Issues (Solved)
.
Last edited by peshkohacka on Sun Jun 22, 2014 6:37 pm, edited 1 time in total.
Re: 360 Spoof Issues (Solved)
.
Last edited by peshkohacka on Sun Jun 22, 2014 6:34 pm, edited 1 time in total.
Re: 360 Spoof Issues (Solved)
I did not replace the serial_init with LUFA's Serial_Init just in case I want to restore the interrupt code.
I just replaced the code in serial_init with a call to Serial_Init.
I just replaced the code in serial_init with a call to Serial_Init.
GIMX creator