Board compatibility

[mikadoryu]

sorry for my English because I am currently using a translator.


I wonder if this development board serves to use the gimx:



Features
ATMega 32U4 running at 5V/16MHz.
Supported under Arduino IDE v1.0 (un-comment "leonardo" lines in boards.txt).
On-Board micro-USB connector for programming.
4 x 10-bit ADC pins.
12 x Digital I/Os (5 are PWM capable).
Rx and Tx Hardware Serial Connections.
Our Smallest Arduino-Compatible Board Yet!.

[Matlo]

It should be compatible as it uses the same chip as the teensy 2.0.

[mikadoryu]

thanks for replying, I'll see if I buy it because the teensy in my country I could not find, my last question is this teblero this CP2102 USB to RS232 TTL should work?

[HIGH5]

^Yes.

[Matlo]

Note that you may have issues to load the firmware.
It's not as easy as with the Teensy 2.0 (the Teensy loader can only be used with Teensy boards).