failed to read packet header from the GIMX adapter
Re: failed to read packet header from the GIMX adapter
Yes you have to select Pro Micro but I don't understand why you want to use Builder instead of gimx-loader. It's much easier to use.
My hardware: PS3 Slim CFW 4.80 | PS4 Pro 500 Million LE | PS5 | Xbox Series X
Steam: Godlike_RU | PSN: GoDlike_RU | XBL: GoDlike
Steam: Godlike_RU | PSN: GoDlike_RU | XBL: GoDlike
Re: failed to read packet header from the GIMX adapter
there is no option for pro micro, can i use gimx-loader to write for first time?
what about red led in arduino ?
and there is no led turn on in USB to UART adapter CP2102 !
what about red led in arduino ?
and there is no led turn on in USB to UART adapter CP2102 !
Re: failed to read packet header from the GIMX adapter
Yes, gimx-loader should work.
However, any of the following issues will make it fail: incorrect wiring, faulty contact, defective hardware, defective cable, incorrect operation (like not plugging/unplugging cables when requested, or plugging it to the wrong target).
However, any of the following issues will make it fail: incorrect wiring, faulty contact, defective hardware, defective cable, incorrect operation (like not plugging/unplugging cables when requested, or plugging it to the wrong target).
GIMX creator
Re: failed to read packet header from the GIMX adapter
Wiring is incorrect. CP2102 TXD should be connected to pro micro RXI. CP2102 RXD should be connected to pro micro TXO.
GIMX creator
Re: failed to read packet header from the GIMX adapter
failed to load firmware
Re: failed to read packet header from the GIMX adapter
problem solved, i use short connect between rst and gnd