Arduino builder error

Need help? Ask here and someone will help
Post Reply
BigWolfHS
Posts: 1
Joined: Sat Mar 06, 2021 5:22 pm

Arduino builder error

Post by BigWolfHS »

i have the same issue, every time i try this message apear:

Connecting to programmer: .avrdude: butterfly_recv(): programmer is not responding

avrdude: butterfly_recv(): programmer is not responding
avrdude: butterfly_recv(): programmer is not responding
avrdude: butterfly_recv(): programmer is not responding
avrdude: butterfly_recv(): programmer is not responding
avrdude: butterfly_recv(): programmer is not responding
Found programmer: Id = "Ç"; type = ï
Software Version = D. ; Hardware Version = .
avrdude: butterfly_recv(): programmer is not responding
avrdude: butterfly_recv(): programmer is not responding
avrdude: error: buffered memory access not supported. Maybe it isn't
a butterfly/AVR109 but a AVR910 device?
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
User avatar
LoneWolf81
Posts: 228
Joined: Sat Jun 15, 2019 11:49 am
Location: South Africa

Re: Arduino builder error

Post by LoneWolf81 »

Hi

I split your post to make it easier in future if you have an issue don't post under an old topic as it might get missed.

As for your issue are you following the correct procedure when programming the board, could you also post clear pictures of your adapter and are you using the latest version of GIMX. Also make sure that the cable you are using to connect the AVR side does have data lines to transfer data and not just power.

Instructions from the Wiki to load firmware.

https://gimx.fr/wiki/index.php?title=Gu ... g_firmware
Please Remember to Post your Log file in the support section , that way its easier and faster to start identifying the issue thus helping you to sort it out so you can enjoy GIMX :D .
Post Reply