Calibration de la souris

Avant de calibrer la souris

Régler la sensibilité du jeu au maximum, et régler les DPI de la souris au maximum.

Démarrer la calibration

http://gimx.fr/img/screenshots/Calibration_1.png

Sélectionner Output>GUI dans gimx-bluetooth ou gimx-serial. Puis démarrer emuclient (Start).

http://gimx.fr/img/screenshots/Calibration_2.png

Les valeurs de calibration de la souris apparaissent dans la partie "Mouse calibration" de l'interface graphique.
Le mode de calibration lit les valeurs depuis le fichier de configuration.
Si vous utilisez plusieurs souris, vous pouvez calibrer chaque souris indépendamment.

Instructions globales

Press ctrl+F1 to enable the calibration.

http://gimx.fr/img/screenshots/Calibration_3.png

Press F1 ... F12 to select the parameter, and use the mouse wheel to change the value. Press ctrl+F1 to leave the calibration and save the parameters.

Step-by-step instructions

1. Press ctrl+F1. If you use multiple mice, select the mouse to calibrate with the mouse wheel.
2. Press F2 and select the profile to calibrate with the mouse wheel (generally, profile 1 is for hip fire, and profile 2 is for aiming down the sight).
3. Press F5. If the sight moves, decrease the x dead zone value with the mouse wheel until the sight does not move. Once the sight does not move, increase the x dead zone until the first moving position.
4. Press F6. Set the same value as the x dead zone value.
5. Press F7. Set the dead zone shape value to "rectangle". If the sight moves, set the dead zone shape to "circle", and let it set to "rectangle" otherwise.
6. Press F12 to start a translation test. The sight will move horizontally at different speeds in both left and right directions. A 1:1 translation means the sight should come back near the start point. If it doesn't, use F8 and the mouse wheel to change the x acceleration value.
7. Press F9. Set the same value as the x acceleration value.
8. Press F3. Adjust the x sensitivity to your liking.
9. Press F10 to start a circle test. Adjust the circle radius and speed (F10/F11 + mouse wheel) if necessary. The x/y ratio is properly set if the sight moves in a perfect circle. If it doesn't, adjust the x/y ratio using F4 and the mouse wheel.
10. Press ctrl+F1 to save.