(No difference)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
# Press ctrl+F1. If you use multiple mice, select the mouse to calibrate with the mouse wheel. # Press F2 and select the profile to calibrate with the mouse wheel (generally, profile 1 is for hip fire, and profile 2 is for aiming down the sight). # Press F3. If the sight moves, decrease the x dead zone value with the mouse wheel until the sight does not move. Once the sight does not move, increase the x dead zone until the first moving position. # Press F4. Set the same value as the x dead zone value. # Press F5. Set the dead zone shape value to "rectangle". If the sight moves, set the dead zone shape to "circle", and let it set to "rectangle" otherwise. # Press F6 to start a translation test. The sight will move horizontally at different speeds in both left and right directions. A 1:1 translation means the sight should come back near the start point. If it doesn't, use F7 and the mouse wheel to change the x acceleration value. Note that it's not always possible to get a 1:1 translation (this depends on the game). # Press F8. Set the same value as the x acceleration value. # Press F9. Adjust the x sensitivity to your liking. # Press F10 to start a circle test. Adjust the circle radius and speed (F10/F11 + mouse wheel) if necessary. The x/y ratio is properly set if the sight moves in a perfect circle. If it doesn't, adjust the x/y ratio using F12 and the mouse wheel. # Press ctrl+F1 to save.
