gimx 1.10 Help

[Johnny Ridden]

As for me, there was not a problem with gimix 1.02

However, Gimx-serial cannot start if I revise it

A window opens in spite of a start and is closed immediately

My os is windws8

[Matlo]

Did you update the firmware of your DIY USB adapter?

[Johnny Ridden]

Yes, I did it

I tried it on a EMUPS3 and a Joystick.

[Matlo]

Using the EMUPS3 firmware, is the teensy detected as a "Playstation 3 controller" when plugged to your computer?

[Johnny Ridden]

Yes
I recognize it

[Matlo]

Is the tx pin of your teensy correctly wired to the serial adapter?

[Johnny Ridden]

Yes
I tried TX and TX filler RX and RX

[Matlo]

Type Win+r, and open cmd.
In the command window, type:

Code: Select all

cd "C:\Program Files (x86)\GIMX"
emuclient -p COM12 -c PS3_FarCry3.xml

Replace COM12 with your serial port, and PS3_FarCry3.xml with your config file.

If "No controller detected." is displayed, this means there is something wrong with your wiring or your hardware. In this case, please post a clear picture of your adapter.

[Johnny Ridden]

http://kie.nu/1rXM
http://kie.nu/1rXO
http://kie.nu/1rXR

Is there the problem with an adapter?

[Matlo]

Where did you buy the atmega32u4 board?