Flip/Flop switch for a second teensy board ?
Posted: Sat Oct 06, 2012 7:23 pm
Hello.
I was thinking about purchasing all stuuf need for a second GIMX DIY USB controller but I tough that it would be great if only one box can do both of them at any time.
I tough putting 2 teensy board behind the UART board in a Y solution with a mechanical 4 poles switch like this one.
But wonder if someone could manage easy and small electronical a flip/flop ic solution.
I would prefer non mechanical switch.
Any ideas and advice are welcome.
Kind regards
/0uistyty
I was thinking about purchasing all stuuf need for a second GIMX DIY USB controller but I tough that it would be great if only one box can do both of them at any time.
I tough putting 2 teensy board behind the UART board in a Y solution with a mechanical 4 poles switch like this one.
But wonder if someone could manage easy and small electronical a flip/flop ic solution.
I would prefer non mechanical switch.
Any ideas and advice are welcome.
Kind regards
/0uistyty