BlackCat USB
Posted: Fri Jun 01, 2012 1:08 am
I have one of these http://blackcatusbjtag.com/, as you guys can see the chip is supported but I don't know where to connect the jumper cables in this one. can anyone help me out?
Page 1 of 1
Re: BlackCat USB
Posted: Fri Jun 01, 2012 2:39 pm
Please post high-res photos of both pcb sides.
Re: BlackCat USB
Posted: Sat Jun 02, 2012 12:17 am
found this. will take the photos tomorrow.
Re: BlackCat USB
Posted: Sat Jun 02, 2012 8:44 am
There is nothing connected to the rx/tx pins...
According to the page 3 of the datasheet the rx pin is at the bottom on the left side, and the tx pin is at the left on the bottom side.
According to the page 3 of the datasheet the rx pin is at the bottom on the left side, and the tx pin is at the left on the bottom side.
Re: BlackCat USB
Posted: Sat Jun 02, 2012 9:39 am
So ill have to solder it?
I might BE wrong but I think the RX point is connected to the upper middle pin.
Ok I soldered some wires and this board works. thanks for the help
. Now let's start configuring stuff
I might BE wrong but I think the RX point is connected to the upper middle pin.
Ok I soldered some wires and this board works. thanks for the help
. Now let's start configuring stuff