Page 1 of 1
DIY GIMX Please Help
Posted: Wed Aug 21, 2024 6:59 pm
by Keify Peat
Hi All
I am in the process of making my own GIMX adapter as I'm unable to buy one. I have followed all the steps in the guide but I cannot figure out where to download the atmega32u4.hex to upload to the Teensy adapter? Any help with this would be much appreciated
EDIT. Sorry Google chrome was blocking the download, however still can't get my DIY GIMX to work.. No new device found within 10 seconds error
Re: DIY GIMX Please Help
Posted: Thu Aug 22, 2024 6:55 pm
by ckaiycool
Keify Peat wrote: ↑Wed Aug 21, 2024 6:59 pm
Hi All
I am in the process of making my own GIMX adapter as I'm unable to buy one. I have followed all the steps in the guide but I cannot figure out where to download the atmega32u4.hex to upload to the Teensy adapter? Any help with this would be much appreciated
EDIT. Sorry Google chrome was blocking the download, however still can't get my DIY GIMX to work.. No new device found within 10 seconds error
I would check the soldering on those cables. Sounds like you have bad connection. If they are not soldered and you use those cables with plugs it will most likely be the fault.
Hope this helps.
Re: DIY GIMX Please Help
Posted: Mon Mar 03, 2025 2:32 am
by helendam
Keify Peat wrote: ↑Wed Aug 21, 2024 6:59 pm
Hi All
I am in the process of making my own GIMX adapter as I'm unable to buy one. I have followed all the steps in the guide but I cannot figure out where to download the atmega32u4.hex to upload to the Teensy adapter? Any help with this would be much appreciated
EDIT. Sorry Google chrome was blocking the download, however still can't get my DIY GIMX to work.. No new device found within 10 seconds error
Ensure your Teensy 2.0 or 2.0++ is in bootloader mode before flashing.
Press the reset button on the Teensy before attempting to upload the hex file.