Some mapped buttons not working
Posted: Thu Jan 20, 2022 6:01 pm
I'm trying to get my Simucube 2 Pro to work with NFS Heat (PC to PC).
I'm using the GIMX adapter with the following setup:
- Both USB ends plugged into the same PC
- Firmware: EMUG27.hex
- Config: LogitechG27_G29.xml as base for customization
I managed to map my steering, gas brake and clutch axis and get these recognized by the Logitech software as well as in game, no issue.
However, the strange thing is with the buttons, I mapped the R1 and L1 buttons (gear up and down) to the shifter paddles on my button box, and these also worked fine in the Logitech software and in game.
However, when I tried mapping the other buttons for triangle, square, cross, etc. to the same button box, these are recognized by the Logitech software but not in game. If I plug in a separate game controller, the buttons on the controller are recognized by the game, but not those that I mapped in GIMX.
Can anyone please advise? Thank you.
I'm using the GIMX adapter with the following setup:
- Both USB ends plugged into the same PC
- Firmware: EMUG27.hex
- Config: LogitechG27_G29.xml as base for customization
I managed to map my steering, gas brake and clutch axis and get these recognized by the Logitech software as well as in game, no issue.
However, the strange thing is with the buttons, I mapped the R1 and L1 buttons (gear up and down) to the shifter paddles on my button box, and these also worked fine in the Logitech software and in game.
However, when I tried mapping the other buttons for triangle, square, cross, etc. to the same button box, these are recognized by the Logitech software but not in game. If I plug in a separate game controller, the buttons on the controller are recognized by the game, but not those that I mapped in GIMX.
Can anyone please advise? Thank you.