I connect both ends to the same computer, USB is not a sleeping port.
Windows 10 x64 Home Edition
Updated all the drivers, everything is up to date.
Internet is working fine.
I choose "G27" from the list, and hit "OK", and I get the confirmation prompt for GIMX adapters only, and then it tells me to disconnect the USB cable and reconnect it.
As soon as I pull the cable out, it gives me a "No new device found within 10 seconds" error.
I purchased my GIMX adapter directly from your store. It's been in the box since I bought it because I never had time to test it.
I have tried a different cable and it didn't work. Also this is a brand new Xbox One controller usb cable and I verified it works with my wired controller.
I don't think this is a cable issue. I also tried on my desktop and another laptop, both with updated Arduino drivers. I believe this device is faulty... Was it tested before being shipped?
Cannot update firmware
Re: Cannot update firmware
Did you do it like this:
Connect both sides to your computer
Start gimx-loader, select the firmware, click on "Load", and "Validate" a single time
Unplug the USB cable from computer (pro micro side)
Click on "Validate" (be quick)
Replug the USB cable (be quick)
Connect both sides to your computer
Start gimx-loader, select the firmware, click on "Load", and "Validate" a single time
Unplug the USB cable from computer (pro micro side)
Click on "Validate" (be quick)
Replug the USB cable (be quick)
Gimx Configs https://drive.google.com/drive/folders/ ... share_link
FRAGnStein/Scorch https://drive.google.com/drive/folders/ ... share_link
FRAGnStein/Scorch https://drive.google.com/drive/folders/ ... share_link
Re: Cannot update firmware
Make sure you replug the correct cable. Try the other end.
My hardware: PS3 Slim CFW 4.80 | PS4 Pro 500 Million LE | PS5 | Xbox Series X
Steam: Godlike_RU | PSN: GoDlike_RU | XBL: GoDlike
Steam: Godlike_RU | PSN: GoDlike_RU | XBL: GoDlike