Page 1 of 1
hi help me
Posted: Sun Oct 31, 2021 4:13 am
by nach09
Hello
I have a problem starting GIMX
It appears to me "Failed to read packet header from gimx adapter"
Re: hi help me
Posted: Sun Oct 31, 2021 10:38 am
by GoDlike
Please check the cables.
Also please post the log file -
viewtopic.php?t=691
Re: hi help me
Posted: Sat Nov 06, 2021 7:10 pm
by nach09
Could it be that it is not useful to have the cables connected without soldering?
sorry if it is not understood, is that my language is Spanish
https://ibb.co/CKY9q2Y
https://ibb.co/kKnpV15
Re: hi help me
Posted: Sat Nov 06, 2021 7:21 pm
by ckaiycool
Test tx to rx and rx to tx between the microcontroller and uart.
If that does not work rx to rx and tx to tx.
Looking at the switch option you need to switch the black switch to left position and 1/2 switch to lower position as it is shown on picture 4
Re: hi help me
Posted: Sat Nov 06, 2021 7:26 pm
by nach09
If I was able to load the hex file with GIMX-LOADER, is it because it recognizes the adapter that I made?
this is the CP2102 i'm using
https://articulo.mercadolibre.com.ar/ML ... -3v-5v-_JM
Re: hi help me
Posted: Sat Nov 06, 2021 7:33 pm
by ckaiycool
Check the picture i linked and set it to the 4 option and see if that works.
Re: hi help me
Posted: Sat Nov 06, 2021 7:38 pm
by nach09
I have already configured it like this in the fourth image
but it would be necessary to try the thing from rx to rx and tx to tx
Re: hi help me
Posted: Sat Nov 06, 2021 8:08 pm
by nach09
Re: hi help me
Posted: Sat Nov 06, 2021 9:25 pm
by nach09
thanks, i just had to do this
https://ibb.co/n0ZdCjz
Re: hi help me
Posted: Sun Nov 07, 2021 7:09 am
by ckaiycool
Well done