[SOLVED]gimx ; supplied user buffer is not valid
Posted: Fri May 10, 2019 10:33 am
good evening ,
i recently made my own gimx adapter but unable to get it working
my parts is : 1) Arduino leonardo R3
2) CP2102 5 pin usb to ttl
what i did ; 1) connect [Tx-Rx ; Rx-Tx ; Gnd-Gnd] from converter to leonardo
2) plugged both end to my laptop and install driver for cp210X and leonardo
3) used gimx-loader , selected EMUG29PS4 , double tap the reset button of the leonardo
and flashed succesfully
4) unplugged both converter and leonardo
5) plugged in g27 , a turned off ds4 , converter to my laptop
6 ) plugged in leonardo to ps4
7) ran gimx launcher and downloaded necessary config
8) port showed up just fine (COM10) , clicked start
9) error usb adapter not detected
10) swapped TX/RX possition , not working
11) reverted to older version of gimx (7.9) not working..
User Esalem mentioned in his thread that he had to swap gnd around to get it working , my leonardo has 3 pins labelled gnd , but none of them return a success
Things i tried : swap tx/rx , swap usb cable , reinstalling all driver (usbdk , etc etc) , reflashing firmware .
Worth noting that , out of frustuation , i tried connecting only one pin (tx) and it showed diffrent problem . This verifies that the serial converter sees the leonardo , but refuse to talk to it when both are connected (doesnt matter the tx/rx possition , return same error anyway)
Anything that i am missing ?
target : ps4 , logitech g27 , sony official ds4
wiring : https://photos.app.goo.gl/Y9Yz1bTKnyGFikky8
https://photos.app.goo.gl/j95Hp7M5dSmuAZ7F6
logs : https://pastebin.com/MD74wSJL
i recently made my own gimx adapter but unable to get it working
my parts is : 1) Arduino leonardo R3
2) CP2102 5 pin usb to ttl
what i did ; 1) connect [Tx-Rx ; Rx-Tx ; Gnd-Gnd] from converter to leonardo
2) plugged both end to my laptop and install driver for cp210X and leonardo
3) used gimx-loader , selected EMUG29PS4 , double tap the reset button of the leonardo
and flashed succesfully
4) unplugged both converter and leonardo
5) plugged in g27 , a turned off ds4 , converter to my laptop
6 ) plugged in leonardo to ps4
7) ran gimx launcher and downloaded necessary config
8) port showed up just fine (COM10) , clicked start
9) error usb adapter not detected
10) swapped TX/RX possition , not working
11) reverted to older version of gimx (7.9) not working..
User Esalem mentioned in his thread that he had to swap gnd around to get it working , my leonardo has 3 pins labelled gnd , but none of them return a success
Things i tried : swap tx/rx , swap usb cable , reinstalling all driver (usbdk , etc etc) , reflashing firmware .
Worth noting that , out of frustuation , i tried connecting only one pin (tx) and it showed diffrent problem . This verifies that the serial converter sees the leonardo , but refuse to talk to it when both are connected (doesnt matter the tx/rx possition , return same error anyway)
Anything that i am missing ?
target : ps4 , logitech g27 , sony official ds4
wiring : https://photos.app.goo.gl/Y9Yz1bTKnyGFikky8
https://photos.app.goo.gl/j95Hp7M5dSmuAZ7F6
logs : https://pastebin.com/MD74wSJL