Output failure
Posted: Wed Sep 28, 2011 12:38 am
Hi there, I've had the program working (after a lot of head scratching and very careful reading...) without a problem until I started really messing around with the configuration.
Now when I start emuclient, the GUI (and even the terminal) opens very briefly before shutting down again. I've noticed that another user has had a similar problem in another thread but his/hers was solved by using another keyboard. However:
I've tried using an external keyboard but to no avail. Even selecting a different config file doesn't work.
I know my bluetooth dongle works because I spent a little time punching and kicking with it and the "Please connect a controller to the PS3" message disappears and stays away until I stop the emuclient. Even restarting the emuclient makes the message go away again.
Here's what my configuration looks like - I haven't touched anything under the overall tab
http://s57.photobucket.com/albums/g215/ ... onfig1.png
http://s57.photobucket.com/albums/g215/ ... onfig2.png
I have also written a new macro file if that helps but other than what I have named it and the key that I used was the same as I used before and it worked so... I'm quite out of ideas what I did wrong to upset the program.
EDIT: Figures... It was either because I added a new file into the macro folder, it was because I had some uppercase letters in the file name or (most likely this one) there was overlapping buttons/input keys in the new text file similar to the example one.
Also, now that I think about it/look at what I've done... Since I'm using all four shoulder buttons as well... Shoulder buttons and not analogue inputs, I should probably add them into the button tab rather than the axis tab... >.>;
"Oh you English are SO superior!"
Now when I start emuclient, the GUI (and even the terminal) opens very briefly before shutting down again. I've noticed that another user has had a similar problem in another thread but his/hers was solved by using another keyboard. However:
I've tried using an external keyboard but to no avail. Even selecting a different config file doesn't work.
I know my bluetooth dongle works because I spent a little time punching and kicking with it and the "Please connect a controller to the PS3" message disappears and stays away until I stop the emuclient. Even restarting the emuclient makes the message go away again.
Here's what my configuration looks like - I haven't touched anything under the overall tab
http://s57.photobucket.com/albums/g215/ ... onfig1.png
http://s57.photobucket.com/albums/g215/ ... onfig2.png
I have also written a new macro file if that helps but other than what I have named it and the key that I used was the same as I used before and it worked so... I'm quite out of ideas what I did wrong to upset the program.
EDIT: Figures... It was either because I added a new file into the macro folder, it was because I had some uppercase letters in the file name or (most likely this one) there was overlapping buttons/input keys in the new text file similar to the example one.
Also, now that I think about it/look at what I've done... Since I'm using all four shoulder buttons as well... Shoulder buttons and not analogue inputs, I should probably add them into the button tab rather than the axis tab... >.>;
"Oh you English are SO superior!"