Game Input MultipleXer

Hi, csr8510 A10 need a special configuration for work on Ubuntu 14.10 ?

A weird think is happening. Couple days ago i have tried to run gimx with a DGI01 and had a terrible lag (10 second and more ).
Today i brought a Hama csr8510 A10. When i to run gimx-launcher and hit " new " only PS Tools is appearing asking for sixaxis/ds3.
I plug the ps3 controller and the second PS Tool appear and the controller and console mac is correctly detected. Until here all fine. When i hit ok, a third windows should appear with the dongle mac, but is not.
On dmsg when i re-enter the dongle i get the following meaning that the dongle is recognized.

[ +11,055933] usb 7-1: new full-speed USB device number 6 using uhci_hcd
[ +0,375014] usb 7-1: New USB device found, idVendor=0a12, idProduct=0001
[ +0,000005] usb 7-1: New USB device strings: Mfr=0, Product=2, SerialNumber=0
[ +0,000004] usb 7-1: Product: CSR8510 A10

What can i do about it ?
Thanks.

Please try with Ubuntu 14.04. It's the only officially supported version.

Nope, is acting same.


[ 5093.624026] usb 7-1: new full-speed USB device number 7 using uhci_hcd
[ 5093.793310] usb 7-1: New USB device found, idVendor=0a12, idProduct=0001
[ 5093.793315] usb 7-1: New USB device strings: Mfr=0, Product=2, SerialNumber=0
[ 5093.793318] usb 7-1: Product: CSR8510 A10
[ 5306.624095] usb 7-1: USB disconnect, device number 7
[ 5311.688025] usb 7-1: new full-speed USB device number 8 using uhci_hcd
[ 5311.857384] usb 7-1: New USB device found, idVendor=0a12, idProduct=0001
[ 5311.857388] usb 7-1: New USB device strings: Mfr=0, Product=2, SerialNumber=0
[ 5311.857392] usb 7-1: Product: CSR8510 A10
[ 5356.472099] usb 7-1: USB disconnect, device number 8
[ 5371.840026] usb 7-1: new full-speed USB device number 9 using uhci_hcd
[ 5382.005415] usb 7-1: New USB device found, idVendor=1131, idProduct=1001
[ 5382.005421] usb 7-1: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[ 5382.005425] usb 7-1: Product: ISSCBTA

Both dongle are recognized by system

What's the output of the following command:?