Page 2 of 3
Re: DIY USB Touchpad
Posted: Tue Oct 06, 2015 5:53 pm
by Matlo
It looks OK. The "finger1 x" and "finger1 y" are not displayed due to a bug.
Are you sure you upgraded the firmware to EMUPS4 5.0?
Re: DIY USB Touchpad
Posted: Tue Oct 06, 2015 6:14 pm
by Reloaded87
how check firmware version?) i have chip atmega32u4 what program use to flash hex? Andruino builder give error port no found
Re: DIY USB Touchpad
Posted: Thu Oct 08, 2015 7:25 am
by Matlo
If the DS4 touchpad is correctly transfered through GIMX to the PS4, this means the EMUPS4 5.0 firmware was correctly loaded.
Maybe the mouse sensitivity in the third profile is too low, you can try increasing it.
Re: DIY USB Touchpad
Posted: Thu Oct 08, 2015 6:41 pm
by Reloaded87
my mouse max support 3200 dpi, 3200 dpi set, touchpad dont work.
Re: DIY USB Touchpad
Posted: Fri Oct 09, 2015 5:21 pm
by Reloaded87
Do you have any idea how fix that problem?
Re: DIY USB Touchpad
Posted: Sat Oct 10, 2015 9:59 am
by Matlo
Is your PS4 software up-to-date?
Re: DIY USB Touchpad
Posted: Sat Oct 10, 2015 2:22 pm
by Reloaded87
yes
Re: DIY USB Touchpad
Posted: Sun Oct 11, 2015 2:09 pm
by Reloaded87
How update firmware on -
http://ru.aliexpress.com/item/50cs-lot- ... 21499.html , if i am plug in usb port, windows no found this device.
Re: DIY USB Touchpad
Posted: Mon Oct 12, 2015 3:15 pm
by Matlo
The Arduino Bootloader can't be reached because the GIMX firmware reprograms the USB interface.
You need an ISP to unlock it, but this may be tricky. You should buy a Teensy 2.0 instead, it will avoid you a lot of issues.
Re: DIY USB Touchpad
Posted: Mon Oct 12, 2015 8:15 pm
by Reloaded87
with firmware 4.3 and gimx 5.0 touchpad direction control does not work, right?