Teensy Purchased at pjrc.com.
http://pjrc.com/store/teensy.html
USB= USB 2.0 TO TTL UART,CP2102(chipset) 6 PIN SERIAL CONVERTER MODULE , NEW BLACK EBAY
https://www.dropbox.com/s/gvzjz56jqu2c7 ... 3.jpg?dl=0
Teensy Firmware EMUG29PS4 atmega32u4.hex
PS4 controller is recognized by windows as HID compliant input device
Trying to use Logitect Driving Force Pro
PC Windows 10
I tried the RX/TX wire swap. No joy.
This is the message I get.
https://www.dropbox.com/s/vta30ush8wufe ... 3.jpg?dl=0
Any and all help would be greatly appreciated
DIY connector issues
Re: DIY connector issues
Reinstall GIMX and install USBDK as suggested at the end of the installation.
GIMX creator