DIY Adpater PS3 Not Functioning

[NingDynasty]

Software Version 1.01
Windows 7 32 bit
DIY USB Adapter (teensy 2.0++, cp2102)
PS3 Slim
None (GT5 once I get it working)
Keyboard

Pastebin of Config (although I also tried some of the pre installed ones)
http://pastebin.com/9GbiSWP6

Image of my adapter


The ps3 will recognize it as a controller however none of my input on the keyboard does anything. I tested my cp2102 using the Arduino IDE and the echo test worked across all baudrates. No other devices hooked up to pc or ps3. Thank you in advance for any assistance you can provide.

[Matlo]

Is your teensy board recognized as a joystick when it is connected to a PC?

[NingDynasty]

Yes I forgot to mention I did that test as well. I also swapped the rx and tx around on the cp2102 even though they are clearly marked just because its such a common problem.

[Matlo]

Does the Output>GUI mode show the right actions?

Did you tried to map the adapter as first controller?

[NingDynasty]

Does the Output>GUI mode show the right actions?

Yes it does, it'll show the corresponding input when I press the buttons. Left(255), Right(255), Up(255), Circle(255), Square(255) ect.

Did you tried to map the adapter as first controller?

I'm not quite sure what you mean by map, but I do plug it into the first usb port on the ps3.

[Matlo]

Did you install the CP2102 drivers?

[NingDynasty]

Yes

[Matlo]

What firmware runs on your ps3?

[FiASCO2]

Hi, same problem!

Spoiler: show

Windows 8 Pro 64bit

I have CFW Rogero 4.41

Teensy firmware ok

[Matlo]

Ok I'll try with the new CP2102 drivers after work.