BlackCat USB

[tiagalho]

I have one of these http://blackcatusbjtag.com/, as you guys can see the chip is supported but I don't know where to connect the jumper cables in this one. can anyone help me out?

[Matlo]

Please post high-res photos of both pcb sides.

[tiagalho]

found this. will take the photos tomorrow.

[Matlo]

There is nothing connected to the rx/tx pins...

According to the page 3 of the datasheet the rx pin is at the bottom on the left side, and the tx pin is at the left on the bottom side.

[tiagalho]

So ill have to solder it?
I might BE wrong but I think the RX point is connected to the upper middle pin.

Ok I soldered some wires and this board works. thanks for the help . Now let's start configuring stuff