USB adaptor question?

Need help? Ask here and someone will help
Post Reply
TheDancer
Posts: 9
Joined: Thu May 10, 2012 8:21 pm

USB adaptor question?

Post by TheDancer »

Hello guys,
I currently live in Bulgaria and i can't find "Teensy" adapter. So that's what i can find: CLICK or will this work: CLICK if not, can you try finding one for me in the following website: CLICK
User avatar
Matlo
Posts: 5768
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: USB adaptor question?

Post by Matlo »

The "noogroove board" from ebay should work. The firmware to load is the same as the at90usb162.
GIMX creator
TheDancer
Posts: 9
Joined: Thu May 10, 2012 8:21 pm

Re: USB adaptor question?

Post by TheDancer »

Thanks for the fast response, but i don't see any pins on it.
PP:CLICK will this one work?
User avatar
Matlo
Posts: 5768
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: USB adaptor question?

Post by Matlo »

No.
GIMX creator
TheDancer
Posts: 9
Joined: Thu May 10, 2012 8:21 pm

Re: USB adaptor question?

Post by TheDancer »

I'm not very experienced with such boards, do you think i'll be able to locate where to put the cables on non-pin board?
User avatar
Matlo
Posts: 5768
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: USB adaptor question?

Post by Matlo »

D2 and D3 are written on the board.
D2 = Rx
D3 = Tx

The wiring is the same as this one:


You will have to solder wires as there are no pins.

Pressing the two on-board buttons (HWB + RESET) allows to enter the programming mode.
GIMX creator
TheDancer
Posts: 9
Joined: Thu May 10, 2012 8:21 pm

Re: USB adaptor question?

Post by TheDancer »

Thank you very much, i would love to support what you're doing somehow! ;)
TheDancer
Posts: 9
Joined: Thu May 10, 2012 8:21 pm

Re: USB adaptor question?

Post by TheDancer »

I just received the development board (NooElec's one). There is one problem and i'm not sure where the problem is. When i connect the board to my laptop and i load Teensy's software for loading a firmware it does not recognize the board. I tried with Atmel's FLIP it does not recognize the board too. Please, help me.
Regards,
Samuil
laytonanthony
Posts: 74
Joined: Fri Apr 27, 2012 7:32 pm

Re: USB adaptor question?

Post by laytonanthony »

it wont untill you put the board into programming mode. is there 2 buttons on the board? if so try holding both then letting go of the 1 while holding the other. usb has to be plugged into laptop/pc. not sure which 1 to let go first so try with both.
Post Reply