Hello guys,
I currently live in Bulgaria and i can't find "Teensy" adapter. So that's what i can find: CLICK or will this work: CLICK if not, can you try finding one for me in the following website: CLICK
USB adaptor question?
Re: USB adaptor question?
The "noogroove board" from ebay should work. The firmware to load is the same as the at90usb162.
GIMX creator
Re: USB adaptor question?
Thanks for the fast response, but i don't see any pins on it.
PP:CLICK will this one work?
PP:CLICK will this one work?
Re: USB adaptor question?
I'm not very experienced with such boards, do you think i'll be able to locate where to put the cables on non-pin board?
Re: USB adaptor question?
D2 and D3 are written on the board.
D2 = Rx
D3 = Tx
The wiring is the same as this one:
You will have to solder wires as there are no pins.
Pressing the two on-board buttons (HWB + RESET) allows to enter the programming mode.
D2 = Rx
D3 = Tx
The wiring is the same as this one:
You will have to solder wires as there are no pins.
Pressing the two on-board buttons (HWB + RESET) allows to enter the programming mode.
GIMX creator
Re: USB adaptor question?
Thank you very much, i would love to support what you're doing somehow!
Re: USB adaptor question?
I just received the development board (NooElec's one). There is one problem and i'm not sure where the problem is. When i connect the board to my laptop and i load Teensy's software for loading a firmware it does not recognize the board. I tried with Atmel's FLIP it does not recognize the board too. Please, help me.
Regards,
Samuil
Regards,
Samuil
-
- Posts: 74
- Joined: Fri Apr 27, 2012 7:32 pm
Re: USB adaptor question?
it wont untill you put the board into programming mode. is there 2 buttons on the board? if so try holding both then letting go of the 1 while holding the other. usb has to be plugged into laptop/pc. not sure which 1 to let go first so try with both.