Tried the USB bluetooth but getting lag. i have 2 minimus development boards i used for psgroove. the chip has an atmel AT90USB162 chip so should do the trick.
All i need is the pins for the Rx and TX and Gnd.
Does anybod no the pins for this?
Minimus AVR USB V1 connections!
-
laytonanthony
- Posts: 74
- Joined: Fri Apr 27, 2012 7:32 pm
Minimus AVR USB V1 connections!
Hey guys
Tried the USB bluetooth but getting lag. i have 2 minimus development boards i used for psgroove. the chip has an atmel AT90USB162 chip so should do the trick.
All i need is the pins for the Rx and TX and Gnd.
Does anybod no the pins for this?
Tried the USB bluetooth but getting lag. i have 2 minimus development boards i used for psgroove. the chip has an atmel AT90USB162 chip so should do the trick.
All i need is the pins for the Rx and TX and Gnd.
Does anybod no the pins for this?
-
laytonanthony
- Posts: 74
- Joined: Fri Apr 27, 2012 7:32 pm
Re: Minimus AVR USB V1 connections!
manage to find the pinouts for this board here.
these development boarda re only £4.00 cheap alternative
these development boarda re only £4.00 cheap alternative
-
laytonanthony
- Posts: 74
- Joined: Fri Apr 27, 2012 7:32 pm
-
peshkohacka
Re: Minimus AVR USB V1 connections!
.
Last edited by peshkohacka on Sun Jun 22, 2014 6:35 pm, edited 1 time in total.
-
laytonanthony
- Posts: 74
- Joined: Fri Apr 27, 2012 7:32 pm
Re: Minimus AVR USB V1 connections!
To confirm this MINMUS AVR USB V1 works fine. i have 2 of them and have used both to make leads.
The reason i used these was because i already had them for the old psgroove hack when it first came out. £4 does the trick if you ask me. also the usb to serial was £3 so a total spend of £7....not bad at all.
The reason i used these was because i already had them for the old psgroove hack when it first came out. £4 does the trick if you ask me. also the usb to serial was £3 so a total spend of £7....not bad at all.