Game Input MultipleXer

Hello guys,

Please, i need your help! I've made a driving simulator for my pc and some games does not recognize it as a controller. So, my only hope is GIMX. Please help me get my board from topic title get ready for this. I've spent at least 20h tryng to get the firmware and get things done, but i got in a non-return point.

LE: So, i uploaded g27 firmware on 32u4, using avrdude,

Connecting to programmer: .
Found programmer: Id = "CATERIN"; type = S
Software Version = 1.0; No Hardware Version given.
Programmer supports auto addr increment.
Programmer supports buffered memory access with buffersize=128 bytes.

Programmer supports the following devices:
Device code: 0x44

avrdude.exe: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.00s

avrdude.exe: Device signature = 0x1e9587
avrdude.exe: reading input file "atmega32u4.hex"
avrdude.exe: writing flash (4440 bytes):

Writing | ################################################## | 100% 0.46s



avrdude.exe: 4440 bytes of flash written
avrdude.exe: verifying flash memory against atmega32u4.hex:
avrdude.exe: load data flash data from input file atmega32u4.hex:
avrdude.exe: input file atmega32u4.hex contains 4440 bytes
avrdude.exe: reading on-chip flash data:

Reading | ################################################## | 100% 0.14s



avrdude.exe: verifying ...
avrdude.exe: 4440 bytes of flash verified

avrdude.exe: safemode: Fuses OK

avrdude.exe done. Thank you.



but board goes off after that.

nobody? :-s

I see you uploaded a firmware. Now you should connect adapter to the PC and test it. Did you do that?

hello,

i did. i have connected both usb on my PC, but led from ITSY BITSY 32U4 16MHZ 5V stays off, and in device manager there's nothing recognized after uploading the firmware. I have also connected USB from board to PS4 and the other one on PC, but still the same, no device detected.

It is expected to see no device attached until you click start in gimx.

GoDlike wrote: ↑Sun Sep 12, 2021 7:11 am It is expected to see no device attached until you click start in gimx.

i still can't belive is true. thanks for your help!