Hello, I made my self a gimx adapter. I updated firmware fine when I tried first time but now I coulnd't and I'm getting Connecting to programmer: .avrdude: butterfly_recv(): programmer is not responding error. Can you please help?
https://hizliresim.com/wjCths
https://hizliresim.com/ZL2qRb
https://hizliresim.com/eK0ptI
https://hizliresim.com/0XNJmA
Uploaded photo on hizliresim.com
What am I doing wrong? (Connecting to programmer: .avrdude: butterfly_recv(): programmer is not responding)
-
- Posts: 1
- Joined: Wed Oct 14, 2020 9:54 pm
- LoneWolf81
- Posts: 235
- Joined: Sat Jun 15, 2019 11:49 am
- Location: South Africa
Re: What am I doing wrong? (Connecting to programmer: .avrdude: butterfly_recv(): programmer is not responding)
Hi
It actually looks like you have TX to TX and RX to RX you should just check the wiring. When everything is working I would recommend you solder permanent wires as using jumpers can sometimes cause issues.
As for your problem when you program the firmware you plug both sides of the adapter into the computer and when prompted you unplug and re plug the cable going to the AVR board it should then update you have 10 seconds to do this. If you still don't get it to work just connect the AVR board and when prompted quickly short out RST and GND on the AVR.
It actually looks like you have TX to TX and RX to RX you should just check the wiring. When everything is working I would recommend you solder permanent wires as using jumpers can sometimes cause issues.
As for your problem when you program the firmware you plug both sides of the adapter into the computer and when prompted you unplug and re plug the cable going to the AVR board it should then update you have 10 seconds to do this. If you still don't get it to work just connect the AVR board and when prompted quickly short out RST and GND on the AVR.
Please Remember to Post your Log file in the support section , that way its easier and faster to start identifying the issue thus helping you to sort it out so you can enjoy GIMX .