Game Input MultipleXer

Hello friends

Beforehand I must to say that I rode everything but I can't fix the problem. In fact, I build two units for checking soldier or extra issue and I've got the same answer.
Im building the adapter with an Mini USB ATmega23U4 Pro and a CP2102 UART TTL 5PIN

The wheel is a Logitech Driving Force Pro

I connect the cables as in the image and I tried to cross RX-TX as well
Loading firmware from Gimx-launcher
Connect to laptop win10 PS4 controller, the weel and the USB cp2012 and in the PS4 the Leonardo

When I try to load gimx-launcher always the same error in both units.


opción global -l con valor `log.txt'
opción global -c con valor `LogitechDrivingForcePro_G29.xml'
controlador #1: opción -p con valor `COM6'
leyendo argumentos del controlador #2
flag de estado determinada
subpos flag determinada
flag force_updates determinada
auto-grab flag is set
GIMX 8.0 i386
Windows 10 (or later) x64
Kernel version: 10.0 (18362)
Error: failed to read packet header from the GIMX adapter
Error: failed to read packet header from the GIMX adapter
Error: failed to read packet header from the GIMX adapter
Error: failed to read packet header from the GIMX adapter
Error: failed to read packet header from the GIMX adapter
Error: failed to read packet header from the GIMX adapter
Error: failed to read packet header from the GIMX adapter
Error: failed to read packet header from the GIMX adapter
Error: failed to read packet header from the GIMX adapter
Error: failed to read packet header from the GIMX adapter

I don't know the next step. I tried everything,.

Hi

Please post clear pictures of your adapter, can you also confirm that the firmware loading was successful and you did not receive any errors.

The firmware is loaded ok. It spend many secdonds after reboot the system (RST+GND)
I don't know how can I add photos, can you help me?

I sent you a pm with my email so you can send me photos.

Here are a few other things you can try.

Is the PS4 switched on when you start GIMX ?

Have you tried other cables between the console and the adapter ? (Some cables only have power wires and no data wires)

Is your wiring as follows, some boards are mislabeled so you can swap the TX and RX and try again

CP210x Leonardo
GND GND
TX RX
RX TX

Your wiring looks correct, I would recommend you solder the wires instead of using jumper cables.
Problem solved was firmware based

Thanks to lonelywolf81 I can enjoy my Logitech Driving Firce pro.
As que says My mistake was to select the wrong firmware.

Thanks friend !!