No controller and adapter connected
-
- Posts: 5
- Joined: Sat Jun 27, 2020 7:01 pm
No controller and adapter connected
I have gimx on my RPI 3 and have everything set up how it should be (adapter plugged in with teensy going into the pi, and a controller plugged in). I know the cable works because I use it daily for a pro wired controller (not the one I plugged into the pi). I have tried switching RX and TX to no avail, any help?
- LoneWolf81
- Posts: 235
- Joined: Sat Jun 15, 2019 11:49 am
- Location: South Africa
Re: No controller and adapter connected
Hi
Please add a log file also what firmware did you load onto the teensy is the teensy a clone or genuine ?
Post clear pictures of the adapter and what uart adapter are you using ?
Please add a log file also what firmware did you load onto the teensy is the teensy a clone or genuine ?
Post clear pictures of the adapter and what uart adapter are you using ?
Please Remember to Post your Log file in the support section , that way its easier and faster to start identifying the issue thus helping you to sort it out so you can enjoy GIMX .
Re: No controller and adapter connected
Teensy/atmega32u4 side should be connected to the target (gaming console).
For further help please provide the details requested by LoneWolf81.
For further help please provide the details requested by LoneWolf81.
GIMX creator