I've Pro Micro atmega32u4 5v/16MHz with connected CP2102.
When Pro Micro has empty sketch uploaded with Arduino app and all connected to my Mac I see this two devices connected to USB:
- CP2102 USB to UART Bridge Controller
- Arduino Leonardo
After successful flashing EMUPS3 firmware using avrdude and reconnecting Pro Micro it's not detected as any USB device (excluding bootloader mode).
But I was expecting to see something like Sony Dualshock 3 controller in USB devices list on Mac, isn't it?
I know GIMX not supported my Mac, but I'm trying to setup USB adapter first.