Page 2 of 2

Re: failed to read packet header from the GIMX adapter

Posted: Mon Feb 04, 2019 11:34 am
by GoDlike
Yes you have to select Pro Micro but I don't understand why you want to use Builder instead of gimx-loader. It's much easier to use.

Re: failed to read packet header from the GIMX adapter

Posted: Mon Feb 04, 2019 11:43 am
by Davros
there is no option for pro micro, can i use gimx-loader to write for first time?
what about red led in arduino ?
and there is no led turn on in USB to UART adapter CP2102 !

Re: failed to read packet header from the GIMX adapter

Posted: Mon Feb 04, 2019 2:01 pm
by Matlo
Yes, gimx-loader should work.

However, any of the following issues will make it fail: incorrect wiring, faulty contact, defective hardware, defective cable, incorrect operation (like not plugging/unplugging cables when requested, or plugging it to the wrong target).

Re: failed to read packet header from the GIMX adapter

Posted: Mon Feb 04, 2019 3:26 pm
by Davros
pls help this time i do eveyting good
Image
Image
Image
Image

Re: failed to read packet header from the GIMX adapter

Posted: Mon Feb 04, 2019 4:19 pm
by Matlo
Wiring is incorrect. CP2102 TXD should be connected to pro micro RXI. CP2102 RXD should be connected to pro micro TXO.

Re: failed to read packet header from the GIMX adapter

Posted: Mon Feb 04, 2019 4:29 pm
by Davros
failed to load firmware

Re: failed to read packet header from the GIMX adapter

Posted: Mon Feb 04, 2019 4:44 pm
by Davros
problem solved, i use short connect between rst and gnd