Page 1 of 2
failed to read packet header from the GIMX adapter
Posted: Thu Jan 31, 2019 11:58 am
by Davros
hi
i build my GIMX adaptor with these :
https://translate.google.com/translate? ... micro.html
https://translate.google.com/translate? ... l2303.html.
i load EMUPS4->atmega32u4.hex with arduino builder 1.0.13 and i get a screen.
then i try to use the Adapter i connect Micro Usb to PS4 and the Usb to the Pc then Start
i get "failed to read packet header from the GIMX adapter"
first
then
Re: failed to read packet header from the GIMX adapter
Posted: Thu Jan 31, 2019 12:13 pm
by Matlo
Try using gimx-loader instead:
https://backup.gimx.fr/wiki/index.php?t ... g_firmware
Make sure the wiring is correct. If it's not gimx-loader will fail to load the firmware.
Re: failed to read packet header from the GIMX adapter
Posted: Thu Jan 31, 2019 12:33 pm
by Davros
Connecting to programmer: .avrdude: butterfly_recv(): programmer is not responding
Re: failed to read packet header from the GIMX adapter
Posted: Thu Jan 31, 2019 12:48 pm
by Matlo
Post a clear picture showing the wiring.
Re: failed to read packet header from the GIMX adapter
Posted: Thu Jan 31, 2019 12:58 pm
by Davros
Re: failed to read packet header from the GIMX adapter
Posted: Thu Jan 31, 2019 1:02 pm
by Davros
is there any way to flash or reboot arduino pro micro ?
i try short connect with GRD and RST
Re: failed to read packet header from the GIMX adapter
Posted: Thu Jan 31, 2019 1:03 pm
by Davros
arduino pro micro is not in arduino builder!!
Re: failed to read packet header from the GIMX adapter
Posted: Thu Jan 31, 2019 1:08 pm
by Davros
for first time i load the firmware there was A Com 4 but after that it's gone !!!
Re: failed to read packet header from the GIMX adapter
Posted: Thu Jan 31, 2019 1:42 pm
by Matlo
The COM port not being here anymore suggest that firmware was correctly loaded.
However the wiring/soldering looks bad.
Remove the electrical tape and solder the green/yellow/blue wires directly on the pro micro board.
Also I can't be sure from the pictures but I think the tin quality is bad.
Re: failed to read packet header from the GIMX adapter
Posted: Mon Feb 04, 2019 11:17 am
by Davros
i buy a new arduino pro micro first of all
i get a red led in arduino and no led in CP2303 !!!
and one of them i must select for arduino pro micro ?!