Page 1 of 1
Can't change the controller USB port
Posted: Thu Jan 03, 2019 10:33 am
by Abslt_strw
Hello everyone, just a simple trouble here. When i first assemble my gimx and configure it was plugged in the front ports of my PC now I want to set it the main ports of the motherboard in the rear part of the PC. The arduino itself doesnt present this problem. Its recognized in the back . The trouble here is the controller. I've already tried replaging with Zadig in the new port but still the same
any thoughts?? THNX by the way
Re: Can't change the controller USB port
Posted: Thu Jan 03, 2019 11:24 pm
by Matlo
Using Zadig is not needed at all. You can just uninstall the driver.
For further help, please provide a log file as requested in forum rules:
viewtopic.php?f=5&t=691
Re: Can't change the controller USB port
Posted: Fri Jan 04, 2019 6:41 am
by Abslt_strw
Uninstall the driver for the controller and then just install it again in the port i want? I'll try and post an update.
Re: Can't change the controller USB port
Posted: Fri Jan 04, 2019 8:43 am
by Abslt_strw
I've done that and now when I try to run the gimx it loads but it stays in the black screen just before when it says normally to press the guide button in the controller
Re: Can't change the controller USB port
Posted: Fri Jan 04, 2019 5:14 pm
by kaiba_seto2004
But does it work or not? Please provide log file.
Re: Can't change the controller USB port
Posted: Sun Jan 06, 2019 11:10 am
by Abslt_strw
Sorry for the late reply. I've been using it without problem in the front USB port. But no chance at all with the rear one... And it's not the port because it works well with any other thing. Uninstall the driver and also the gimx itself clean install and no luck with it... Plugged it again in the front and it connected at the first time.
Re: Can't change the controller USB port
Posted: Sun Jan 06, 2019 7:39 pm
by Matlo
Looks like an operating system / driver issue. Check if there are driver updates for your hardware.