Can't change the controller USB port

Need help? Ask here and someone will help
Post Reply
Abslt_strw
Posts: 11
Joined: Fri Aug 03, 2018 9:27 pm

Can't change the controller USB port

Post by Abslt_strw » Thu Jan 03, 2019 10:33 am

Hello everyone, just a simple trouble here. When i first assemble my gimx and configure it was plugged in the front ports of my PC now I want to set it the main ports of the motherboard in the rear part of the PC. The arduino itself doesnt present this problem. Its recognized in the back . The trouble here is the controller. I've already tried replaging with Zadig in the new port but still the same :( any thoughts?? THNX by the way

User avatar
Matlo
Posts: 5351
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: Can't change the controller USB port

Post by Matlo » Thu Jan 03, 2019 11:24 pm

Using Zadig is not needed at all. You can just uninstall the driver.

For further help, please provide a log file as requested in forum rules: viewtopic.php?f=5&t=691
GIMX creator Donate Shop

Abslt_strw
Posts: 11
Joined: Fri Aug 03, 2018 9:27 pm

Re: Can't change the controller USB port

Post by Abslt_strw » Fri Jan 04, 2019 6:41 am

Uninstall the driver for the controller and then just install it again in the port i want? I'll try and post an update.

Abslt_strw
Posts: 11
Joined: Fri Aug 03, 2018 9:27 pm

Re: Can't change the controller USB port

Post by Abslt_strw » Fri Jan 04, 2019 8:43 am

I've done that and now when I try to run the gimx it loads but it stays in the black screen just before when it says normally to press the guide button in the controller

User avatar
kaiba_seto2004
Posts: 324
Joined: Sat Jul 15, 2017 9:15 am

Re: Can't change the controller USB port

Post by kaiba_seto2004 » Fri Jan 04, 2019 5:14 pm

But does it work or not? Please provide log file.
PS4 enthusiast.

Abslt_strw
Posts: 11
Joined: Fri Aug 03, 2018 9:27 pm

Re: Can't change the controller USB port

Post by Abslt_strw » Sun Jan 06, 2019 11:10 am

Sorry for the late reply. I've been using it without problem in the front USB port. But no chance at all with the rear one... And it's not the port because it works well with any other thing. Uninstall the driver and also the gimx itself clean install and no luck with it... Plugged it again in the front and it connected at the first time.

User avatar
Matlo
Posts: 5351
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: Can't change the controller USB port

Post by Matlo » Sun Jan 06, 2019 7:39 pm

Looks like an operating system / driver issue. Check if there are driver updates for your hardware.
GIMX creator Donate Shop

Post Reply