Stuck on "Press the PS button to activate the controller"
Posted: Sat Sep 01, 2018 10:15 pm
Hi, i searched for it, but my config seems to be rare.
I have DIY USB (Arduino Uno R3 + CP2102), Logitech G27, Windows 10 Laptop and Playstation 4.
I have updated firmware EMUG29PS4.hex with ATMEL Flip.
I connect to the laptop:
- the wheel,
- the CP2102 ,
- the powered off DS4
And connected the Uno to the powered on PS4
Then I starts Gimx-launcher, it looks like this (https://imgur.com/kU0ciRU). When I press "Check" it returns "This config seems OK!".
Then I press "Start" and get this (https://imgur.com/Y5Fqa5N).
But when I press PS button mapped on the wheel nothing happens. Looking at the log file, it seems like the adapter is detecting the PS button press on the wheel, but for some reason the command isn't being sent to the PS4.
The log file link is https://pastebin.com/4225SP7Z and i'm using the default G27 to G29 config file.
I already tried different cables between the UNO and the PS4, but haven't got any different result. I know that using a UNO isn't "supported", but i just can't see where's the error on my config.
gimx-launcher 7.8 x86_64
PS4 software 5.56
I have DIY USB (Arduino Uno R3 + CP2102), Logitech G27, Windows 10 Laptop and Playstation 4.
I have updated firmware EMUG29PS4.hex with ATMEL Flip.
I connect to the laptop:
- the wheel,
- the CP2102 ,
- the powered off DS4
And connected the Uno to the powered on PS4
Then I starts Gimx-launcher, it looks like this (https://imgur.com/kU0ciRU). When I press "Check" it returns "This config seems OK!".
Then I press "Start" and get this (https://imgur.com/Y5Fqa5N).
But when I press PS button mapped on the wheel nothing happens. Looking at the log file, it seems like the adapter is detecting the PS button press on the wheel, but for some reason the command isn't being sent to the PS4.
The log file link is https://pastebin.com/4225SP7Z and i'm using the default G27 to G29 config file.
I already tried different cables between the UNO and the PS4, but haven't got any different result. I know that using a UNO isn't "supported", but i just can't see where's the error on my config.
gimx-launcher 7.8 x86_64
PS4 software 5.56