Page 1 of 1
Diy adapter error
Posted: Wed Aug 01, 2018 8:28 am
by kamperkilla87
Hey Matlo any idea on this error? Flashed the arduino, an replaced the controller drivers. Still getting this error. Thanks in advance
Re: Diy adapter error
Posted: Wed Aug 01, 2018 8:29 am
by kamperkilla87
Oh an by the way the controller is updated as well. Also the controller shows up in device manager as libusbk...
Re: Diy adapter error
Posted: Wed Aug 01, 2018 11:03 am
by Matlo
Replacing the controller driver is no more needed. Please check the guide for your use case. You can easily generate it from the main page of the wiki.
Regarding the error, please provide a few more details. Is this a new setup? If yes, does the UsbDk driver install successfully? You can try installing it manually from the GIMX install directory (it should be in the tools/UsbDk directory). If no, was there any software and/or hardware change lately?
Re: Diy adapter error
Posted: Wed Aug 01, 2018 6:32 pm
by kamperkilla87
I'm helping a friend trying to get his working. So should I have him delete the controller drivers an do a fresh install of gimx?
Re: Diy adapter error
Posted: Thu Aug 02, 2018 10:09 am
by GoDlike
That would be a good idea IMHO.
Re: Diy adapter error
Posted: Thu Aug 02, 2018 3:27 pm
by Matlo
Yes, it's better to have the libusbk driver uninstalled. And please check UsbDk installation completes sucessfully.