Page 1 of 2
problem in gimx launcher (please help)
Posted: Sat May 05, 2018 8:46 am
by shabaa
Re: problem in gimx launcher (please help)
Posted: Sat May 05, 2018 8:58 am
by GoDlike
Check your wiring. Something is wrong with the adapter. Make sure cables are fine and TX/rx isn't inverted.
Re: problem in gimx launcher (please help)
Posted: Sat May 05, 2018 11:51 am
by shabaa
I'm sure the wires are connected all good
Re: problem in gimx launcher (please help)
Posted: Sat May 05, 2018 11:54 am
by shabaa
My console is xb1
Re: problem in gimx launcher (please help)
Posted: Sat May 05, 2018 10:42 pm
by kamperkilla87
shabaa wrote: ↑Sat May 05, 2018 11:54 am
My console is xb1
Did you flash the pro micro with the right firmware?
Re: problem in gimx launcher (please help)
Posted: Sun May 06, 2018 6:10 pm
by Matlo
Re: problem in gimx launcher (please help)
Posted: Mon May 07, 2018 12:30 pm
by shabaa
When uploading a file atmega32u4.hex !!
"Error - file not found"
Re: problem in gimx launcher (please help)
Posted: Mon May 07, 2018 12:41 pm
by GoDlike
Use gimx-loader that's included with gimx. There's no need to use Arduino Builder anymore.
Re: problem in gimx launcher (please help)
Posted: Mon May 07, 2018 12:58 pm
by shabaa
thank you for rebly
look
Re: problem in gimx launcher (please help)
Posted: Mon May 07, 2018 1:01 pm
by shabaa
But I still have the same problem