Stuck on "push PS button"
Posted: Wed Mar 14, 2018 2:23 pm
Hello! It seems to be common problem, but I can't find any answer (
I have DIY USB (Arduino leonardo + UART-USB convertor), Logitech Driving Force GT, Raspberry Pi 3 with Raspbian, Playstation 4.
I have updated firmware EMUG29PS4.hex with Gimx-launcher
I connect
- the wheel,
- the UART-USB convertor,
- the powered off DS4
to the Pi and Arduino to the PS4.
PS4 is powered on.
Then I starts Gimx-launcher, it looks like this (https://imgur.com/O14ma8O). When I press "Check" it returns "This config seems OK!".
Then I press "Start" and get this (https://imgur.com/RxsW1vF). When I press PS button on the wheel just nothing happens with PS4 but the wheel starts control mouse cursor in Raspbian o_o.
gimx-launcher 7.2 ARMv6
PS4 software 5.50
What should I do?
Just yesterday, when I wire it all up it worked fine, but today it reject all my attempts. (
I have DIY USB (Arduino leonardo + UART-USB convertor), Logitech Driving Force GT, Raspberry Pi 3 with Raspbian, Playstation 4.
I have updated firmware EMUG29PS4.hex with Gimx-launcher
I connect
- the wheel,
- the UART-USB convertor,
- the powered off DS4
to the Pi and Arduino to the PS4.
PS4 is powered on.
Then I starts Gimx-launcher, it looks like this (https://imgur.com/O14ma8O). When I press "Check" it returns "This config seems OK!".
Then I press "Start" and get this (https://imgur.com/RxsW1vF). When I press PS button on the wheel just nothing happens with PS4 but the wheel starts control mouse cursor in Raspbian o_o.
gimx-launcher 7.2 ARMv6
PS4 software 5.50
What should I do?
Just yesterday, when I wire it all up it worked fine, but today it reject all my attempts. (