How to check if firmware was uploaded correctly?
Posted: Wed Aug 16, 2017 2:55 pm
Hi all,
I'm using Arduino Leonardo, serial CP2102, and uploadded the EMUXONE.hex (gimx-launcher 6.8 x86) by 'Help -> Update Firmware -> Load'.
The upload was successful (plugging both usb, pressing reset, ...).
How can I check if firmware was uploaded correctly?
If I plug the arduino usb directly on the PC should something come up? (in Device Manager)
...like 'Controller'...
I'm using Arduino Leonardo, serial CP2102, and uploadded the EMUXONE.hex (gimx-launcher 6.8 x86) by 'Help -> Update Firmware -> Load'.
The upload was successful (plugging both usb, pressing reset, ...).
How can I check if firmware was uploaded correctly?
If I plug the arduino usb directly on the PC should something come up? (in Device Manager)
...like 'Controller'...