Changed it to 12.000dpi but it switched automaticly
back to 1.200dpi.
Will try it again and let you know if that will solve it.
Edit:
Changed it manually to 12.000dpi
Did nothing else with the config file. Didnt notice
any diffrence. Even with/without configuration it again.
The jumpy/jittery aim is still present.
My mouse is always on 12.000dpi when i start GIMX
Mouse jitter
Re: Mouse jitter
Editing the config with gimx-config or gomx-fpsconfig causes the issue.
Change the value with a text editor after each time you save the config with gimx-config or gimx-fpsconfig.
I'll fix this issue in the next release (6.6).
Change the value with a text editor after each time you save the config with gimx-config or gimx-fpsconfig.
I'll fix this issue in the next release (6.6).
GIMX creator
Re: Mouse jitter
Changed it with a text editor.
It shows 12.000dpi now when i open the config file again.
But that didnt solve the issue
It shows 12.000dpi now when i open the config file again.
But that didnt solve the issue
Re: Mouse jitter
Did you perform the calibration again? Maybe the dead zone value is too high?
GIMX creator
Re: Mouse jitter
Did the calibration process again.
Still jittery mouse movements. Dont know what it
could be. Its not a config calibration thing i think.
Even with a new or perfect calibrated file it starts to jitter.
The only time i see barely no jitter is when i switch from
“aiming“ mode to “driving“.
But that doesent solve my problem.
The UART converter can run with 3v or 5v TTL
Tried both. Seems to make no difference.
Still jittery mouse movements. Dont know what it
could be. Its not a config calibration thing i think.
Even with a new or perfect calibrated file it starts to jitter.
The only time i see barely no jitter is when i switch from
“aiming“ mode to “driving“.
But that doesent solve my problem.
The UART converter can run with 3v or 5v TTL
Tried both. Seems to make no difference.
Re: Mouse jitter
Yes i tried to lower it.
Low/high deadzone
Low/high sensetivity
Its always the same. As soon as i touch the mouse it starts to jitter.
Low/high deadzone
Low/high sensetivity
Its always the same. As soon as i touch the mouse it starts to jitter.
Re: Mouse jitter
Yes i tried to lower it.
Low/high deadzone
Low/high sensetivity
Its always the same. As soon as i touch the mouse it starts to jitter.
Low/high deadzone
Low/high sensetivity
Its always the same. As soon as i touch the mouse it starts to jitter.
Re: Mouse jitter
Did you check if there is the same behavior on a PC or a laptop?
This may tell if the issue is specific to the RPi3.
This may tell if the issue is specific to the RPi3.
GIMX creator
Re: Mouse jitter
Yes, its the same with my laptop.
Only thing i could test is to hook up the Arduiano directly
to the raspberry pi but i dont have the resistors.
I think the UART converter could cause the problem.
Did you check the link i posted?!
You can see the UART converter i use.
Only thing i could test is to hook up the Arduiano directly
to the raspberry pi but i dont have the resistors.
I think the UART converter could cause the problem.
Did you check the link i posted?!
You can see the UART converter i use.