Page 2 of 2

Re: Xbox One

Posted: Sun Feb 12, 2017 7:12 pm
by Matlo
Maybe there was a problem loading the firmware.
Try reloading firmware 5.8/EMUXONE/atmega32u4.hex, and make sure to click on the "reboot button" (green right arrow).

Re: Xbox One

Posted: Fri Mar 17, 2017 8:31 am
by mysnake
Use this steps:

0> Make sure XBOX One controller is connected to RPI when booting RPI up.
1> Disconnect AVR USB board and USB to UART adapter!! Yes, both USB and Mini USB.
2> Plug the AVR USB board (e.g. Teensy, Arduino Leonardo, Micro Pro...) to the console and wait few seconds.
3> Plug the USB to UART adapter (e.g. CP2102, FT232RL...) to the computer or raspberry and wait few seconds.
4> don't touch pad - GIMX will authenticate it with console and turn the pad on automatically.
5> Start GIMX, perform all config accordingly if needed etc. and play game.