so I installed the firmware then done as follows
after installing firmware on adrunio board I removed it.
I then done following.
-Connected the usb other end of adrunio (cp20102?) to my pc directly.
-Connected the micro usb adunio board to my ps4 via cable.
-Connected a switched off dualshock controller ps4 to my pc via usb cable.
-Connected my Logitech wheel to my pc via usb.
I have:
Logitech driving force usb steering wheel
Arduino Pro Micro Leonardo compatible 5V 16MHz ATmega32U4
PL2303 PL-2303 USB TTL Serial Adapter for ESP8266 like FTDI CP2102 CH340 UK
This what I get:
why cant i get any port on gimx
Re: why cant i get any port on gimx
The PL2303 does not support the required baudrate on Windows.
https://gimx.fr/wiki/index.php?title=DI ... _converter
https://gimx.fr/wiki/index.php?title=DI ... _converter
GIMX creator
Re: why cant i get any port on gimx
so that's the problem?
ok ill buy new parts thanks
it says it takes 5v dunno about the 500kbp though
http://www.ebay.co.uk/itm/261888018066? ... EBIDX%3AIT
ok ill buy new parts thanks
it says it takes 5v dunno about the 500kbp though
http://www.ebay.co.uk/itm/261888018066? ... EBIDX%3AIT