GIMX ran less than 5 secs error

[memoxis44]

Hello there. I have been following your forum for 6 months I read lots of things and finally after believing it actually works ı ordered the components from abroad. ıa got it like a month ago and assembled it. BUT it happens to be not working.

1- I have LOGITECH DFGT
2- I have PS4
3- I have a Lenovo (win 10) and Siemens (win 7) Laptop
4- teensy 2.0 + USB to UART serial converter

issue #1 :
ı assembled the two components and ı tried it on win 10 lenovo laptop
no matter what I chose ı get the message,
the error is "joystick not found (0)"
I downloaded lgs 510 set it up then I tried with dfgt 29 and it says although the "config seems ok "
GIMX ran less than 5 seconds. would you like to create a log report? it says.
And I say YES!
and it says

global option -l with value `log.txt'
global option -c with value `LogitechDrivingForceGT_G29.xml'
controller #1: option -p with value `COM3'
now reading arguments for controller #2
status flag is set
subpos flag is set
force_updates flag is set
GIMX 5.8 x86_64
Windows 10 (or later) x64
Kernel version: 10.0 (10586)
native mode is already enabled for HID device \\?\hid#vid_046d&pid_c29a#6&2e22e55c&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030} (PID=c29a)
src/windows/async.c:246 ReadFile failed with error: Sağlanan kullanıcı arabelleği istenen işlem için geçerli değil.


can't read packet data
No controller detected.
adapter_detect failed


SECONDLY
I really really tried to get it working on siemens lap top but guess what after setting the gimx software I execute the launcher and I get the error "cant retreive the configs "


please please please help

[Matlo]

Hi,
Please don't multiple post.
First issue: which USB to UART adapter are you using?
Second issue: does your laptop have an internet connection?

[memoxis44]

Thanks for the heads up. I did not mean to multiple the post but bad gate away error caused this.
I have an internet connection.
My laptop has 3.0 usb hub
On the usb to uart it says cnewtec.com there is a sign like compass needle.
On the forums it says dfgt works perfectly on the usb 2.0 hub but doesnt have the full compatibility on 3.0
Thanks

[memoxis44]

ı checked the model name cp 2104 usb to uart

[Matlo]

Did you install the CP210x drivers at the end of the GIMX setup?

[memoxis44]

yes

[memoxis44]

ı ordered another 2102 from abroad ı will retry with it. it is exact the same with the photo given in the recipe