global option -l with value `log.txt'
global option -c with value `LogitechG27_G29.xml'
controller #1: option -p with value `COM3'
now reading arguments for controller #2
status flag is set
subpos flag is set
force_updates flag is set
GIMX 5.8 x86_64
Windows 10 (or later) x64
Kernel version: 10.0 (10586)
native mode is already enabled for HID device \\?\hid#vid_046d&pid_c29b#6&fb8579b&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030} (PID=c29b)
ReadFile failed: timeout expired.
can't read packet header
No controller detected.
adapter_detect failed
i make sure the contact of my wires are good. i also tried swapping tx and rx.
plss help.. i wanted to use my logitech g27 to ps4..
i follow the instruction DIY usb adapter for dummies..
i also disable the power saver of the usb root hub..
plss help..
plsss help, stuck on this error..
Re: plsss help, stuck on this error..
Hi,
I moved the topic to the support section.
Did you turn the PS4 on before starting GIMX?
Please post a clear picture showing the wiring.
I moved the topic to the support section.
Did you turn the PS4 on before starting GIMX?
Please post a clear picture showing the wiring.
GIMX creator
-
- Posts: 3
- Joined: Fri May 20, 2016 1:26 pm
Re: plsss help, stuck on this error..
Should i turn on the ps4 first? Before starting gimx? Or the other way?
Thanks for quickresponse..
Thanks for quickresponse..
Re: plsss help, stuck on this error..
Turn on ps4 first
-
- Posts: 3
- Joined: Fri May 20, 2016 1:26 pm
Re: plsss help, stuck on this error..
for your reference.. i attached the picture of the wiring..
Re: plsss help, stuck on this error..
I'm unsure the GND pin on the Teensy is correctly soldered.
Which firmware did you load?
Which firmware did you load?
GIMX creator