Talk about anything concerning the source code.
Post Reply
Posts: 1
Joined: Sun Jan 08, 2017 8:49 am


Post by alibob » Sun Jan 08, 2017 8:55 am


I would like to start a new project with GIMX. I'm hoping that this way I'm able to connect a LG DFGT driving wheel to my xbox 360. There I need a DIY usb cable, usb to serial.
And I'm using Odroid. Arm based like RPi, but there's some little differences. Example the UART line is 1,8V ... oport_uart

So my question is, is it even possible to use Odroid for this purposes? And if it is, then I might need the "voltage divider" mentioned in the RPi guide: =

Thank you for your help! :)

User avatar
Posts: 5365
Joined: Wed Jul 06, 2011 7:01 am
Location: France

Re: USB-UART 1.8V?

Post by Matlo » Sun Jan 08, 2017 10:45 am

1.8V is probably too low. The atmega32u4 may not consider it as a high level. An active logic level converter is probably required.
GIMX creator Donate Shop

Post Reply