Page 1 of 2

Will this TTL adapter work?

Posted: Wed Apr 11, 2018 5:58 pm
by kamperkilla87
@Matlo thanks. I'd like to leave some positive feedback. Also I want to make an adapter myself for a friend. I have a arduino pro micro already. Will this ttl adapter work along with it?


https://www.amazon.com/gp/aw/d/B00LODGR ... ref=plSrch

Re: Macros

Posted: Fri Apr 20, 2018 4:59 pm
by kamperkilla87
@Matlo will this ttl adapter work along with the arduino pro micro?

Re: Will this TTL adapter work?

Posted: Fri Apr 20, 2018 7:47 pm
by GoDlike
Hello,

I split the topic because the next question was quite different from the first one.

Regards,
Daniel

Re: Will this TTL adapter work?

Posted: Tue Apr 24, 2018 8:46 pm
by Matlo
Yes, it should work fine.

Re: Will this TTL adapter work?

Posted: Tue Apr 24, 2018 9:53 pm
by Gevorian
I have the same one, works fine.

Re: Will this TTL adapter work?

Posted: Mon Apr 30, 2018 6:54 pm
by kamperkilla87
Here is the arduino an the ttl adapter. I've read the diy adapter wiki but am confused on what needs to be soldered together. Also what do i need to flash? The arduino? Ttl adapter? Or both?

Image

Re: Will this TTL adapter work?

Posted: Tue May 01, 2018 6:19 am
by kamperkilla87
Sorry, I reread the wiki. Its working like a charm.

Re: Will this TTL adapter work?

Posted: Tue May 01, 2018 6:33 pm
by kamperkilla87
SOMETHINGS WRONG. I put the adapter together last night an it was working fine. i used it for a while last night with no issues, an today i also used it for a little bit with no problems. I recently tried to start up gimx with the diy adapter an was met with an error. it also stated gimx ran less than five seconds. if that helps. i tried using my GIMX store bought adapter an everything works as it should.

here is the log file

https://pastebin.com/X7Rqbn0t

Re: Will this TTL adapter work?

Posted: Wed May 02, 2018 6:54 pm
by Matlo
Look for bad contacts and/or faulty USB cables.

Re: Will this TTL adapter work?

Posted: Thu May 03, 2018 12:40 am
by kamperkilla87
Checked continuity between the arduino an ttl adapter an everything is fine. Connections are solid, using legs an jumper cables. Still failing to start sometimes. I get it working after a few failed attempts. An when it works it works until stopping it without any error.