Game Input MultipleXer

Managed to find a CSR8510 dongle for $10. Fingers crossed it works

Sorry for all the posts. But I finally managed to get it to work! Unfortunately it's far from playable. There's a very noticeable 4-6 seconds of delay from when I press a button to when it registers on the PS4. For a start the lag is only 1-3 seconds then it quickly goes up to 4-6 seconds and my ter...

I should mention that it did work once, and after that I'm just getting the refused error. I don't happen to have any of the compatible adapters listed on the wiki. Is there any way I could proceed with the bluetooth route? Or any route at all that it's going to work with. EDIT! Managed to get anoth...

Okay! I'm making progress (I think). Thanks for being so patient. I'm able to get gimx-launcher to recognize everything now. However, when I press the PS button on my controller after I've started gimx-launcher, it gives me this error: listening on psm: 0x0001 listening on psm: 0x0011 listening on p...

nump

Alright. Bit of an update, sorry about the wait. I'm trying it with Ubuntu 14.04 with no avail, however I noticed that you can use Bluetooth on Ubuntu with gimx. I get as far as when it tells me to connect my teensy, however I'm using a pro micro (mega32u4) and it doesn't seem to recognize it at tha...

Yep. Also, my CP2102 arrived and using that didn't make a difference either.

Alright, I managed to get hold of a voltmeter to use for a bit. The TX and RX pins were outputting the correct voltage so I'm clueless as to what the issue is anymore.

Just resoldered the pin into the RX socket and it still doesn't want to work for me. On the same row as GND, RX and TX I also have the following sockets available: 2, 3, 4, 5, 6, 7, 8, 9 And on the other side of the board I have the following: RAW, GND, RST, VCC, A3, A2, A1, A0, 15, 14, 16, 10 Pleas...

I'll give it a try tomorrow then report back! Thanks for the help