Game Input MultipleXer

I tried again just to confirm it was broken, and it works now. Likely rebooting my computer had something to do with it, but I have no idea why. Answering the questions for completeness: Have you tried to press the reset button quickly after you choose firmware and press Load? Yep, I did this yester...

New Leonardo arrived in the mail today. An actual Arduino Leonardo, rather than a clone on a small board Ground <> Ground, two TX <> RX connections. This caused my CP2102 to show a blue and red light now, vs just a red light with my old ATmega32U4. I bet that board was dead. Followed your steps exac...

You should plug both cables to PC, run gimx-loader and then replug leonardo cable. This will force it to go bootloader mode. GIMX-loader will detect the change and flash the firmware. I had the feeling something wasn't right here. I had both plugged in, but unplugging/plugging the Leonardo had no e...

Back when GT Sport came out, I was able to use a CP2102 > "Arduino Leonardo" Robotdyn Micro ATmega32U4 (5V, 16MHz) successfully with a Logitech G27 to emulate a G29, using GIMX 6.11 Now that GT7 is out, I wanted to see if I could get it working with my rig that now has a Fanatec clubsport ...